13 62 592 Removing and installing/replacing pressure sensor on right intercooler (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work:

DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles

Necessary preliminary tasks:

Read out fault memory of DME control unit
Turn off ignition
Remove FAN COWL

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of right intercooler.

Installation note:

Replace sealing ring on pressure sensor.

Fig 1: Identifying Plug, Right Intercooler Pressure Sensor And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.