13 62 560 Removing and installing/replacing left or right air-mass flow sensor (N63 hybrid)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
High-voltage system - danger to life!
WARNING:
The following points must be strictly observed prior to starting work:
- DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
- Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Turn off ignition
- REMOVE HEAT SHIELD
Picture shows the left side, the procedure for the right side is identical.
Unlock plug (1) and remove.
Unfasten screws (2).
Tightening torque 13 62 6AZ .
Pull air-mass flow sensor (3) out of upper section of intake filter housing.
Installation note:
Replace gasket on air-mass flow sensor.
NOTE:
Check stored fault message.
Delete fault memory.
Delete fault memory.