13 62 531 Replacing coolant temperature sensor (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work:

Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles

WARNING: Danger of scalding!
Only perform this work after engine has cooled down.

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Turn off ignition
Remove FAN COWL

Unlock plug (1) and remove.

Unfasten coolant temperature sensor (2).

Installation note:

Tightening torque 13 62 1AZ .

Fig 1: Identifying Plug And Coolant Temperature Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Delete fault memory.

Checking coolant level. If necessary, top up coolant.

Check cooling system for leaks.