13 90 500 Replacing tank vent valve (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work:

DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles

Necessary preliminary tasks:

Check stored fault message
Turn off ignition
Remove FAN COWL

Unlock plug (1) and remove.

Unlock hose (2) and detach.

Unlock hose (3) further below on intake manifold and detach.

Detach tank vent valve (4) from holder and remove.

Fig 1: Identifying Tank Vent Valve, Hose And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock hose (1) on intake manifold and detach.

Fig 2: Identifying Intake Manifold Hose

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Read out fault memory of DME control unit.

Delete fault memory.