37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive): Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove ignition key
Disconnect BATTERY NEGATIVE LEAD
Remove SIDE TRIM PANEL FROM FOOTWELL ON RIGHT A-PILLAR

Fold carpet in footwell at bottom right to one side.

Release screws (1).

Tightening torque 37 14 6AZ .

Fig 1: Identifying Vertical Dynamics Management Control Unit Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) in direction of arrow and disconnect.

Remove control unit.

Fig 2: Disconnecting Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.