67 61 007 Removing and installing/replacing drive with gearbox (rear) for actuating slide/tilt sunroof (rear)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Lower HEADLINING

Disconnect plug connection (1) and if necessary expose cable.

Release screws (2) and remove drive (3).

Tightening torque: see 1AZ in 54 13 ELECTRICAL SLIDE/TILT SUNROOF COMPONENTS .

Fig 1: Identifying Actuating Slid/Tilt Sunroof Drive With Plug Connection And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert gear (1) of electric motor with gearbox for operation of slide/tilt sunroof (2) exactly in gearing (3).

Fig 2: Identifying Gear, Slide/Tilt Sunroof And Gear Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Initialize SLIDE/TILT SUNROOF .