13 62 592 Removing and installing / replacing pressure sensor for charge air on right (N74)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit.
Turn off ignition
Remove right INTAKE FILTER HOUSING

NOTE: Graphic shows the left side, the procedure for the right side is identical.

Release clamp (1).

Tightening torque: see 5AZ in 13 71 AIR INTAKE SYSTEM

Remove hose supports (2).

Fig 1: Identifying Hose Supports And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic shows the left side, the procedure for the right side is identical.

Release screws (1).

Tightening torque: see 7AZ in 13 62 SENDERS FOR CONTROL UNIT

Unlock plug (3) and remove.

Pull pressure sensor (2) out of right charge air duct.

Fig 2: Identifying Pressure Sensor, Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove pressure sensor (2).

Installation:

Replace sealing ring on pressure sensor.

Installation:

Assemble engine.

Delete fault memory.