34 52 525 Replacing one front pulse sensor

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection).

Necessary preliminary tasks:

Remove front WHEEL
Read and comply with GENERAL INFORMATION .

Open housing cover.

Disconnect plug connection (1).

Installation note:

Ensure proper locking of plug connection and proper seating of rubber grommets.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage line (1) along marked lines from holders.

Installation note:

Ensure proper locking of the holders and proper seating of the line in the brackets.

Fig 2: Identifying Brake Pad Sensor Line

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and withdraw pulse sensor (2) from bore hole.

Installation note:

Tightening torque: see 3AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .

Clean bore for pulse sensor and lubricate with Staburags NBU 12/K lubricating grease.

Fig 3: Identifying Screw And Pulse Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Prior to installation, check sensor head for damage and replace if necessary.