61 31 310 Replacing brake light switch

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim panel for pedal mechanism. See TRIM PANEL (US ONLY) or TRIM PANEL (ECE ONLY) .

Disconnect plug connection (1).

Pull brake light switch (2) in direction of arrow out of brake light switch holder (4).

Installation note:

Press brake pedal (3) to floor.
Push brake light switch (2) as far as it will go into brake light switch holder (4).
Counter hold brake light switch (4) holder, slowly return brake pedal (3) to initial position and tighten to stop .

Fig 1: Pulling Brake Light Switch Out Of Brake Light Switch Holder

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Removing brake light switch holder (1):

Press brake pedal.

Unclip brake light switch holder (1) at shanks (2) and remove towards rear.

Fig 2: Identifying Brake Light Switch Holder On Shanks

Courtesy of BMW OF NORTH AMERICA, INC.