61 31 221 Removing and installing/replacing both multifunction steering wheel switches

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove airbag unit. See AIRBAG UNIT or AIRBAG UNIT (SPORT STEERING WHEEL) .
Release both shift paddles if necessary

Release screws (1) on left/right on back of steering wheel (2).

Fig 1: Identifying Steering Wheel Back With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring harness (2).

Feed wiring harness (2) out of steering wheel.

Remove both multifunction steering wheel switches (1) in direction of arrow.

Fig 2: Removing Multifunction Steering Wheel Switches

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove both multifunction steering wheel switches (2).

Installation note:

Make sure electrical wiring is correctly routed.

Fig 3: Identifying Multifunction Steering Wheel Switch With Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.