61 35 240 Removing and installing (replacing) Smart Opener control unit (non-contact rear lid opening)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove COVER ON REAR BUMPER PANEL

Release latch mechanisms (1) and remove control unit (2) in direction of arrow.

Fig 1: Removing Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) from control unit (2) and detach.

Feed out connecting lines from holder (3).

Installation note:

Make sure plug connections (1) and control unit (2) are correctly fitted.

Make sure connecting lines are correctly routed at holder (3).

Fig 2: Identifying Control Unit, Plug Connection And Cable Clips

Courtesy of BMW OF NORTH AMERICA, INC.