54 12 136 Removing and installing/replacing sliding trim for glass slide/tilt sunroof

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove GLASS SLIDE/TILT SUNROOF COVER
Close sliding trim completely

Release screws (1).

Tightening torque 54 12 03AZ .

Remove sliding strips from guide rail.

Installation note:

Make sure rubber lugs are correctly seated on sliding strips.

Remove sliding trim towards front.

Fig 1: Identifying Guide Rail Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Correctly insert front sliding strips into driver (drive cable).

Fig 2: Removing Sliding Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If sliding trim is difficult to move, apply a light coat of Renolit RHF1 (manufactured by Fuchs) to guide duct.