54 12 115 Removing and installing glass slide/tilt sunroof cover
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove GAITER on left and right
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release left and right screws (1).
Remove glass slide/tilt sunroof cover (2) towards top.
Installation note:
Replace screws (1).
Insert screws (1) but do not tighten down yet.
Adjust and initialize GLASS SLIDE/TILT SUNROOF COVER .