65 50 160 Removing and installing/replacing cover for rear cabin monitor display at front and rear

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)

Necessary preliminary tasks:

Remove COVER FOR REAR PASSENGER COMPARTMENT MONITOR AT REAR

IMPORTANT: Do not damage or scratch display.

Release screws (1).

Tightening torque 65 50 1AZ .

Carefully disconnect plug connection (3).

Remove rear passenger compartment monitor (4) from cover (5).

Installation note:

Ensure correct cable routing in guides (2).

Make sure cover (5) is correctly seated on rear passenger compartment monitor (4).

Fig 1: Identifying Plug Connection, Rear Passenger Compartment Monitor, Guides, Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.