65 50 165 Removing and installing/replacing trim for rear monitor display at rear

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)

Necessary preliminary tasks:

REMOVE REAR MONITOR

Release screws (1).

Tightening torque 65 50 1AZ .

Remove cover (3) from rear monitor (4), unclipping plug (2) and feed out cable.

Installation note:

Make sure cover (3) is correctly seated on rear monitor (4).

Fig 1: Identifying Rear Cabin Cover, Monitor, Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.