66 53 020 Removing and installing (replacing) reversing camera
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary work:
- Remove CENTER TRUNK LID TRIM STRIP .
Unlock latch mechanisms (2) and lever reversing camera holder (3) out of center trunk lid trim strip (4).
Feed reversing camera (1) out of camera holder (3).
Replacement:
Remove protective film from lens of reversing camera (1).
Fig 1: Identifying Reversing Camera, Latch Mechanisms, Reversing Camera Holder And Center Trunk Lid Trim Strip
After installation:
- Calibrate REVERSING CAMERA .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .