66 53 010 Calibrating reversing camera
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at trunk lid
IMPORTANT:
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Correct tire pressure (see label on car).
- Vehicle is free of load
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 03/2011!
Service functions:
- Complete vehicle
- Body
- Camera systems