24 34 020 Replacing sealing sleeve for transmission housing (GA6HP26Z) (N63 engine, model years 2009 through 2012)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 2 390

IMPORTANT:

After completing work, check TRANSMISSION OIL LEVEL .

Use only approved TRANSMISSION OIL .

Failure to comply with this instruction will result in serious damage to the transmission!

Necessary preliminary tasks:

IMPORTANT: Support transmission with workshop hoist.

Unlock and disconnect plug (1) by turning.

Fig 1: Disconnecting Plug

G08495686

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Special Tool (24 2 390) In Sealing Sleeve

G08488058

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 3: Sliding Sealing Sleeve

G08512184

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.
Pull out sealing sleeve (1).

Installation:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Fig 4: Pulling Out Sealing Sleeve

G08488060

Courtesy of BMW OF NORTH AMERICA, INC.

Lug on sealing sleeve must not be damaged!