LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3132 (Automatic Transmission - Repair) >> Transmission Case, Oil Sump >> 24 11 010 Removing and installing/sealing or replacing transmission sump (GA6HP26Z) (N63 engine, model years 2009 through 2012)

24 11 010 Removing and installing/sealing or replacing transmission sump (GA6HP26Z) (N63 engine, model years 2009 through 2012)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation.
IMPORTANT:

Remove transmission oil sump only after it has cooled down.

After completing work, check TRANSMISSION OIL LEVEL .

Use only approved TRANSMISSION OIL .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks: 

Remove oil drain plug (1).

Tightening torque 24 11 2AZ .

Drain automatic transmission oil.

Installation note: 

Replace oil drain plug.

Fig 1: Identifying Oil Drain Plug
G04726107Courtesy of BMW OF NORTH AMERICA, INC.

Recycling: 

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

Unscrew all bolts.

Remove transmission oil sump (1).

Installation note: 

Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque 24 11 1AZ .

Fig 2: Locating Transmission Oil Sump Screws
G04726108Courtesy of BMW OF NORTH AMERICA, INC.

Remove gasket (1) from transmission sump.

Clean transmission oil sump to remove residual oil.

Clean sealing faces and groove with a cloth.

Insert new gasket in transmission oil sump groove.

IMPORTANT: Do not degrease transmission oil sump with cleaning agent.
Fig 3: Identifying Transmission Sump Gasket
G04726109Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1) on oil filter tube.

Fig 4: Identifying Sealing Ring On Oil Filter Tube
G04726110Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

The gasket is correctly installed when it is engaged in the locating opening of the transmission oil sump.

Fig 5: Locating Transmission Oil Sump Gasket
G04726111Courtesy of BMW OF NORTH AMERICA, INC.