Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove FRONT BUMPER TRIM
Remove high-pressure nozzle of headlight washer system

Release screw (1) on headlight arm (2) (from wheel arch side). Tightening torque 63 12 1AZ .

Fig 1: Identifying Headlight Arm And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1). Tightening torque 63 12 3AZ .

NOTE: Screw (2) is only fitted in the M3.

Release wiring harness fastener (3) on headlight arm.

Fig 2: Removing Headlight With Bolts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove high-pressure line and wiring harness from headlight arm.

Pull out headlight (4) slightly and disconnect associated plug connection.

Remove headlamp (4) in direction of arrow.

Installation:

Observe GAP DIMENSIONS
Adjust HEADLIGHT