37 14 511 Replacing front ride-height sensor (all-wheel drive vehicle)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disconnect jointed rod (2).

Tightening torque 37 14 3AZ .

Installation note:

Replace nut.

Release screws (3), remove ride height sensor and disconnect plug connection (4).

Tightening torque 37 14 1AZ .

Installation note:

Sensor lever (2) must point from ride height sensor to left front wheel.

Fig 1: Identifying Jointed Rod, Sensor Lever, Nut, Screws, And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check HEADLIGHT ADJUSTMENT , correct if necessary