Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Remove FRONT UNDERBODY PROTECTION
E88: Remove V-strut on left and right
Remove ANTI-ROLL BAR LINK ON BOTH SIDES FROM STABILIZER

M3:

Remove reinforcement plate. Release nut (1) for return line (2).

Tightening torque 32 41 11AZ.

Installation:

Replace self-locking nut.

Fig 1: Identifying Return Line And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Except M3: Release screws (1) and remove brackets.

Release nuts (2); if necessary, grip screws after repair.

Remove stabilizer (3); if necessary, press off front axle carrier with a suitable tool.

Installation:

Check both RUBBER MOUNTS FOR DAMAGE and replace if necessary.

Replace self-locking nuts (do not tighten down).

Set car on its wheels and tighten down nuts to tightening torque 31 35 1AZ .

Fig 2: Identifying Screw, Nuts And Stabilizer

Courtesy of BMW OF NORTH AMERICA, INC.