64 53 550 Removing and installing or replacing capacitor for heating and air conditioning system
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant fluid.
Read and comply with safety information:
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant fluid.
Read and comply with safety information:
- Handling R 134a tetrafluorethane refrigerant . See 6450... SAFETY INSTRUCTIONS FOR HANDLING R134A REFRIGERANT or 6450... INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A
- HANDLING REFRIGERANT FLUID
IMPORTANT:
Risk of damage!
Restart engine only when heating and air conditioning system has been correctly filled.
Restart engine only when heating and air conditioning system has been correctly filled.
NOTE:
Follow NOTES for opening and replacing parts in refrigerant circuit.
If Air conditioning system is opened for more than 24 hours:
REPLACE DESICCANT INSERT FOR HEATING AND AIR CONDITIONING SYSTEM
If Air conditioning system is opened for more than 24 hours:
REPLACE DESICCANT INSERT FOR HEATING AND AIR CONDITIONING SYSTEM
IMPORTANT:
The desiccant insert can only be replaced in vehicles up to 12/08!
In vehicles after 12/08, the air conditioning capacitor must be replaced!
In vehicles after 12/08, the air conditioning capacitor must be replaced!
Necessary preliminary work:
- DRAWING OFF, EVACUATING AND FILLING THE HEATING AND AIR CONDITIONING SYSTEM are not included in the time value given for this job item
- Remove RADIATOR
Release screws (1).
Tightening torque 64 53 1AZ .
Disconnect suction and pressure lines and lay to one side.
Installation note:
Replace sealing rings.
Use special tool 00 9 030 to install sealing rings without damaging them.
Release screw (1).
Lever out clamp (2).
Remove capacitor (3) towards rear.
Installation note:
Make sure retaining clips are correctly seated in area (4).
Installation note:
Make sure capacitor (1) is securely seated in area (2).
After installation: