64 53 515 Replacing desiccant insert for air conditioning system
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Refrigerant circuit is under high pressure!
Follow safety instructions for handling R 134a (tetrafluorethane) refrigerant See 6450... SAFETY INSTRUCTIONS FOR HANDLING R134A REFRIGERANT or 6450... INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A .
Avoid contact with refrigerant and refrigerant fluid.
Follow safety instructions for HANDLING REFRIGERANT FLUID .
Refrigerant circuit is under high pressure!
Follow safety instructions for handling R 134a (tetrafluorethane) refrigerant See 6450... SAFETY INSTRUCTIONS FOR HANDLING R134A REFRIGERANT or 6450... INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A .
Avoid contact with refrigerant and refrigerant fluid.
Follow safety instructions for HANDLING REFRIGERANT FLUID .
IMPORTANT:
Risk of damage!
Restart engine only when air conditioning system has been correctly filled.
Restart engine only when air conditioning system has been correctly filled.
NOTE:
Follow NOTES for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours:
Follow INSTRUCTIONS ON REPLACING DESICCANT INSERT .
If air conditioning system is opened for more than 24 hours:
Follow INSTRUCTIONS ON REPLACING DESICCANT INSERT .
IMPORTANT:
The desiccant insert can only be replaced in vehicles with production dates up to 12/08!
In vehicles after 12/08, the heating and air conditioning system capacitor must be replaced!
In vehicles after 12/08, the heating and air conditioning system capacitor must be replaced!
Necessary preliminary work:
- DRAWING OFF, EVACUATING AND FILLING THE HEATING AND AIR CONDITIONING SYSTEM are not included in the time value given for this job item
- Remove CAPACITOR
If necessary, pierce label over sealing cap (1).
Remove cap (1) from capacitor (2).
Installation note:
Tightening torque 64 53 12AZ . See REFRIGERANT LINES AND EXPANSION VALVE or AIR CONDITIONING COMPRESSOR .
Remove circlip ring (1) with suitable pliers.
With assistance of a screwed-in screw (1), pull the desiccant insert (2) out of the capacitor (3).
After installation:
- Top up and bleed the cooling system and check for watertightness
- EVACUATE AND FILL HEATING AND AIR CONDITIONING SYSTEM