Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove REAR LEFT WHEEL
NOTE:
Read and comply with GENERAL INFORMATION
.
After completing work: BLEED BRAKE SYSTEM .
After completing work: BLEED BRAKE SYSTEM .
Press clutch pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
IMPORTANT:
Grip brake hose at square drive to prevent connecting piece from turning in retaining bracket.
Never twist brake hose (3) when installing it and avoid all contact with parts attached rigidly to the body.
Never twist brake hose (3) when installing it and avoid all contact with parts attached rigidly to the body.
Disconnect brake hose from brake line (1).
Detach brake hose from brake line (2) and remove brake hose (3).
Installation:
Tightening torque 34 32 1AZ .
Installation:
Use torque wrench (Hazet 6282□-1CT with reversible ratchet head).
Tighten brake line using torque wrench (1) and special tool 34 3 170.