Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Remove REAR WHEELS
Remove fuel filler pipe

Release screws (1).

Tightening torque 33 55 1AZ .

Remove retaining bracket (2) and rubber mount (3).

Installation:

Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.

Clean rear anti-roll bar on both sides.

Position rubber mount on rear anti-roll bar.

Fig 1: Identifying Rubber Mount With Retaining Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Position retaining bracket on rubber mount.

Push rubber mount with retaining bracket on rear anti-roll bar to installation position.