Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Remove REAR WHEEL

If necessary, open cover (1) on stoneguard (2).

Mark position of eccentric bolt to rear axle support.

Fig 1: Identifying Cover On Stoneguard

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt.

Tightening torque 33 32 8AZ .

Installation:

If necessary, turn toe arm by hand.

Fig 2: Locating Toe Arm Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove eccentric washer (2).

Tightening torque 33 32 7AZ .

Unscrew eccentric bolt towards front and remove toe arm (3).

Installation:

Bolt head points in direction of travel.

Reinstall eccentric washer.

Replace self-locking nut.

Align eccentric bolt to rear axle support by means of marking.

Fig 3: Removing Toe Arm

Courtesy of BMW OF NORTH AMERICA, INC.