35 31 000 Removing and installing or replacing clutch pedal

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove pedal TRIM .
If necessary, remove OVER-CENTER HELPER SPRING

Disconnect return spring (1).

Press end of pin (2) together with offset pliers and press out pin.

Detach locking clip (3) and pull clutch pedal off bearing block.

Installation:

Replace locking clip (3).

Locking clip (3) must be seated with both legs in the pin groove.

Fig 1: Identifying Return Spring, Pin And Locking Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Fig 2: Identifying Bearing Bushings

Courtesy of BMW OF NORTH AMERICA, INC.