65 50 011 Removing and installing (replacing) video module for onboard monitor

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD .
Remove LUGGAGE COMPARTMENT TRIM ON LEFT .

NOTE: Follow instructions for HANDLING OPTICAL FIBRES .

Unfasten screws (2) and nuts (3).

Pull back video module for on-board monitor (1) and disconnect plug connections.

Remove video module for on-board monitor (1) complete with holder.

Fig 1: Identifying On-Board Monitor With Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (3) and remove holder (2) from video module for onboard monitor (1).

Fig 2: Identifying On-Board Monitor With Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding .