51 47 151 Removing and installing/replacing left luggage compartment wheel arch trim

Necessary preliminary tasks 

• Remove TRIM ON REAR APRON 
• If necessary, remove STORAGE TRAY  in luggage compartment on left

Version with through-loading system: 

• Fold down backrest for left rear seat

Lever out socket (1) in direction of arrow and disconnect plug connection.

Fig 1: Removing Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Guide (1) and catches (2) must not be damaged.

Fig 2: Identifying Guide And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Remove warning triangle (1).

Turn bracket (2) approx. 90° in counterclockwise direction and remove.

Turn bracket (3) approx. 90° in clockwise direction and remove.

Release expansion rivets (4).

Fig 3: Identifying Warning Triangle, Expansion Rivets And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove trim (2).

Pull out luggage compartment wheel arch trim (3) in inwards direction.

Fig 4: Pulling Out Luggage Compartment Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation in version without through-loading system only: 

Installation: 

To install luggage compartment wheel arch trim, proceed as follows:

• Remove REAR SEAT
• Unscrew screws (1).

  Tightening torque 52 24 01AZ .

• Press backrest from luggage compartment in direction of vehicle interior and feed luggage compartment wheel arch trim between wheel arch and backrest

Fig 5: Identifying Backrest Guides And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement 

If necessary, release trim (1) at catches (2) from interior and remove rubber pull (3).

Fig 6: Identifying Trim And Catches

Courtesy of BMW OF NORTH AMERICA, INC.