65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR LEFT WHEEL ARCH COVER

Release screws (1) and lower complete mounting plate (2).

Unlock and disconnect associated plug connection, remove complete mounting plate (2).

Fig 1: Identifying Mounting Plate With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove emergency power siren with tilt sensor (2) from mounting plate (3).

Fig 2: Identifying Tilt Sensor And Mounting Plate With Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding .