41 61 000 Removing And Installing Engine Compartment Lid

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Read general service information under BODY, GENERAL .

Necessary preliminary tasks:

Disconnect all cable plug connections

IMPORTANT: For the following work step, secure the engine hood against falling closed.

Disconnect gas-pressure damper from engine hood (1).

Loosen screws (2).

Release screws (3).

Tightening torque 41 61 1AZ .

Fig 1: Identifying Gas-Pressure Damper With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: This work step must be carried out with a second person assisting.

Remove hood lid.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

If this is not possible, ADJUST ENGINE HOOD .