12 61 285 Removing and installing/replacing oil level sensor for engine oil (S65)
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary work
- Switch off ignition
- Remove REINFORCEMENT PLATE
- Drain off ENGINE OIL
Release connector (1) and remove.
Unscrew nuts.
Tightening torque 13 62 3AZ .
Remove oil level sensor (2).
Installation note:
Clean sealing surface on oil sump.
Replace gasket on oil level sensor.
An excessively low torque value will result in oil leaks.
An excessively high torque value will result in damage to the oil level sensor.
Top up engine oil.