13 62 610 Replacing pulse generator on crankshaft/transmission (S65)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
REMOVE UNDERBODY PROTECTION
Remove REINFORCEMENT PLATE

Release screws (1).

Remove cover.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector and remove.

Release screw (1).

Remove pulse generator.

Fig 2: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.
Add final details to vehicle.