64 11 869 Replacing servodrive for blending flap
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL ASSEMBLY .
Unfasten plug connection (1) and disconnect.
Unfasten screws (2).
Detach servodrive for blending flap (3) in direction of arrow from heater/air conditioner (4).
Installation:
Place servodrive for blending flap (3) over guide pin (5).
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors