64 11 868 Removing and installing/replacing servodrive for defrosting flap (right)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove GLOVEBOX WITH HOUSING

NOTE: For purposes of clarity, the following graphics show the heater/air conditioner removed.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Remove servodrive at side.

Installation:

Do not twist teeth of servodrive.

Fig 1: Identifying Plug Connection With Screws

Courtesy of BMW OF NORTH AMERICA, INC.