51 16 366 Removing and installing right glovebox with housing

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Version with can holder:

Remove both front CUP HOLDERS

Release screws (1).

Pull out glovebox (1) slightly.

Fig 1: Pulling Out Glovebox

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (2) and feed cable out of guide (3).

Depending on version, disconnect further plug connections.

Remove glovebox (1).

Fig 2: Identifying Glovebox, Plug Connections And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) for glovebox must not be damaged or missing.

Version with can holder:

Guides (2) for cup holders must not be damaged or missing.

Fig 3: Identifying Glovebox And Cup Holder Guides

Courtesy of BMW OF NORTH AMERICA, INC.