64 53... Replacing valve insert for refrigerant line
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
Refrigerant circuit is under high pressure!
Follow safety instructions for HANDLING R 134A REFRIGERANT .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.
Refrigerant circuit is under high pressure!
Follow safety instructions for HANDLING R 134A REFRIGERANT .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.
IMPORTANT:
Risk of damage!
Restart engine only when A/C system has been correctly filled.
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!
If A/C system is opened for more than 24 hours:REPLACE DESICCANT INSERT FOR A/C SYSTEM
NOTE:
The special tool is available under BMW order number: 81 34 0 427 679 from the BMW workshop equipment catalogue.
Necessary preliminary tasks:
- DRAWING OFF, EVACUATING AND FILLING THE A/C SYSTEM are not included in the time value given for this work operation
Twist valve insert out of filler neck (2) with remover (1).
Installation:
Screw in valve insert hand-tight only.
After installation
- EVACUATE AND FILL A/C SYSTEM
- Check leak-tightness of valve insert with soapy solution
In event of leakage:
- EVACUATE A/C system
- Check sealing faces on line and valve insert for damage, replace line or valve insert if necessary
- If necessary, carry out LEAK DETECTION