36 11 523 Removing and installing/replacing an RDC trigger transmitter (rear)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Partially detach rear WHEEL ARCH TRIM

After installation

Carry out RESETTING of RDC

Disconnect plug connection (1).

Release screws (2) and remove trigger transmitter.

Fig 1: Identifying Trigger Transmitter Plug Connection With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

E90 and E91 from 09/2008:

Disconnect plug connection (1).

Press holder (2) together and detach trigger transmitter (3) towards front.

Fig 2: Identifying Trigger Transmitter With Holder And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.