34 33 505 Removing and installing or replacing brake booster
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Read and comply with GENERAL INFORMATION .
- Remove BRAKE MASTER CYLINDER
- Remove HYDRAULIC UNIT
- Remove left FOOTWELL TRIM
Detach locking clip (1) from brake pedal, disengage and pull out locking pin.
Unscrew nuts (2).
Installation:
Replace self-locking nuts.
Tightening torque 35 11 1AZ .
IMPORTANT:
Do not use any force when removing and installing the brake unit; the brake unit can be damaged under certain circumstances.
Brake lines must not be bent.
Carefully pull brake booster (1) out of bulkhead and tilt out.
If necessary, disengage brake line from holder on bulkhead and press slightly to one side.
Replacement
Modify NON-RETURN VALVE .