51 34 211 Replacing rubber guide for rear left or right door window

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.

Necessary preliminary tasks

Remove COVER ON INSIDE DOOR WINDOW FRAME
Release TRIM ON WINDOW GUIDE and slide downwards slightly, do not remove

E91 only:

Remove trim on window frame at rear

NOTE: Window cavity cover strip does not have to be removed.

Lever out rubber guide (1) on door window frame at front (2) with special tool 00 9 317.

Fig 1: Removing Rubber Guide On Door Window Frame Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rubber guide (1) out of window guide.

Detach rubber guide (1) in direction of arrow from door.

Fig 2: Pulling Rubber Guide From Window Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Moisten rubber guide (2) prior to fitting with APPROVED ANTI-FRICTION AGENT .

Close door window glass (1) a little.

Push rubber guide (2) onto door window glass (1) and into window guide (3).

Fig 3: Pushing Rubber Guide On Door Window Glass And Window Guide

Courtesy of BMW OF NORTH AMERICA, INC.