33 32 160 Removing and installing/replacing tension strut for rear axle support
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Risk of damage!
Driving without the compression strut is not permitted!
The rear axle support must be supported if it is necessary to replace both compression struts!
Risk of damage!
Driving without the compression strut is not permitted!
The rear axle support must be supported if it is necessary to replace both compression struts!
Necessary preliminary tasks
- Remove UNDERBODY COVER
- Remove rear tension struts
Release nuts (1 and 2).
Slacken screws (3) and release screws (4).
Installation:
Replace self-locking nut.
Tightening torque 51 61 7AZ .
Release screws (1).
Installation:
Tightening torque 33 33 2AZ .
Release screw (2) and remove compression strut (3).
Installation:
Tightening torque 33 33 1AZ .