11 34 560 Replacing all valve stem seals (S65)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove cylinder head See 1112105 REMOVING AND INSTALLING LEFT CYLINDER HEAD (S65) or 1112106 REMOVING AND INSTALLING RIGHT CYLINDER HEAD (S65) .
Remove all VALVE SPRINGS .

Remove valve stem seal with special tool 11 1 480 in direction of arrow.

Fig 1: Removing Valve Stem Seal Using Special Tool (11 1 480)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Attach the mounting sleeve (1) supplied with the new part to the valve stem.

Fig 2: Identifying Mounting Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Attach valve stem seal (2) over mounting sleeve (1).

Fig 3: Identifying Valve Stem Seal And Mounting Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Press on valve stem seal with special tool 11 5 270 in direction of arrow as far as it will go.

Fig 4: Pressing Valve Stem Seal Using Special Tool (11 5 270)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.