Mounting engine on assembly stand (S65)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove engine .
Remove rear water pipe.

Secure special tool 11 5 260 PLATE to crankcase with bolts (2).

Tighten bolts (2) evenly.

NOTE: Bolts (1) are not required on the S65.

Fig 1: Securing Special Tool (11 5 260) To Crankcase With Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Secure engine with special tool 11 5 260 PLATE to special tool 00 2 300 ASSEMBLY STAND .

NOTE: Picture shows S85.

Fig 2: Securing Engine With Special Tool (11 5 260)

Courtesy of BMW OF NORTH AMERICA, INC.