6331004 Removing and installing or replacing complete ceiling light (rear, with module for passenger compartment protection): Notes

Carefully unclip trim of ceiling light (1) with special tool 00 9 341 in direction of arrow from ceiling light and remove.

Fig 1: Unclipping Trim Of Interior Roof Light From Interior Roof Light With Special Tool 00 9 341 In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Version with reading lights: 

Retaining clips (1) are located on centerline of both reading lights.

Carefully unlock retaining clips (1) with special tool 00 9 341.

Fig 2: Positioning Special Tool (00 9 341)

Courtesy of BMW OF NORTH AMERICA, INC.

Version without reading lights: 

Retaining clips (1) are located at distance (A) from outer edges of ceiling light.

(A) = 35 mm

Carefully unlock retaining clips (1) with special tool 00 9 341.

Fig 3: Identifying Retaining Clips, Reflector And Roofliner With Special Tool (00 9 341) - Version Without Reading Lights

Courtesy of BMW OF NORTH AMERICA, INC.

Lever ceiling light (1) with special tool 00 9 341 in direction of arrow out of roofliner (2).

Disconnect plug connection underneath and remove ceiling light (1).

Fig 4: Removing Ceiling Light With Special Tool (00 9 341)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Assemble ceiling light prior to installation:

• Feed in ceiling light trim (1) at line (2)
• Press ceiling light trim (1) in direction of arrow onto ceiling light (3)

Make sure ceiling light trim (1) is correctly engaged on ceiling light (3).

Fig 5: Pressing Interior Roof Light Cover Onto Interior Roof Light In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

• Remove MODULE FOR INTERIOR MOVEMENT DETECTOR
• If necessary, remove BULBS .