6575071 Removing and installing (replacing) module for passenger compartment sensor

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks:

Remove CEILING LIGHT (REAR)

Open retaining shook (1), and detach and remove module for passenger

compartment sensor (2) from trim (3) in direction of arrow.

Installation:

Retaining hooks (1) must not be damaged.

Fig 1: Removing Module For Passenger Compartment Sensor From Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .