2612001 Replacing complete propeller shaft center mount

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove PROPELLER SHAFT .

NOTE: The propeller shaft is balanced. The front and rear propeller shafts must be reassembled in the same position.

Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

Installation:

Make sure gaiter (1) is securely seated in groove (2).

Fig 1: Marking Front Propeller Shaft And Rear Propeller Shaft In One Plane

Courtesy of BMW OF NORTH AMERICA, INC.

Pull propeller shaft apart.

Fig 2: Pulling Propeller Shaft Apart

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, insert new clamping ring (1) into front propeller shaft (2).

Fig 3: Identifying Front Propeller Shaft With Clamping Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

Installation:

Apply a coating of grease to longitudinal splines on shaft.

See PROPELLER SHAFT - OPERATING FLUIDS .

Push gaiter (1) during installation into groove (2) and make sure it is firmly seated.

Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).

Fig 4: Identifying Gaiter And Groove

Courtesy of BMW OF NORTH AMERICA, INC.

Install special tool 00 7 500 between center mount (1) and universal joint (2).

Fig 5: Installing Special Tool (00 7 500) Between Centre Mount And Universal Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Using a hydraulic press, force center mount (1) off propeller shaft (2).

Fig 6: Forcing Centre Mount Off Propeller Shaft Using Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.

Force new center mount (1) onto propeller shaft. Collar (2) must point in direction of travel towards front propeller shaft. Drive center mount firmly home with special tool .

Fig 7: Forcing Centre Mount Onto Propeller Shaft Collar Using Special Tool (23 1 060)

Courtesy of BMW OF NORTH AMERICA, INC.