3111004 Removing and installing/replacing reinforcement brace
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Driving without the reinforcement brace is not permitted!
Driving without the reinforcement brace is not permitted!
Necessary preliminary tasks
Partly detach UNDERBODY PANELLING ON LEFT AND RIGHT in area of reinforcement brace
Release screws (1).
Remove reinforcement brace (2).
Installation:
Replace screws and insertion nuts.
Tightening torque 31 10 2AZ .