Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove STORAGE COMPARTMENT
- Move front seats back completely and lower
- Clamp off BATTERY NEGATIVE LEAD
- Remove STEERING COLUMN
- Remove both TRIMS FOR FRONT ROOF PILLAR
- Remove TRIM PANEL FOR PEDAL ASSEMBLY
- Remove INSTRUMENT CLUSTER
- Remove LIGHT OPERATOR UNIT
- Remove DECORATIVE STRIP ON INSTRUMENT PANEL ON RIGHT
- Remove operator unit for heating and air conditioning system See 6411378 REMOVING AND INSTALLING/REPLACING HEATING - A/C SYSTEM CONTROL PANEL (VERSION WITH CCC/ASK AND CIC) or 6411377 REMOVING AND INSTALLING/REPLACING HEATER/AIR CONDITIONER OPERATOR UNIT (VERSION
- Remove INSERT FOR RADIO CONTROL KEY
- In appropriate version:
- Remove RADIO RECEIVER
- Remove AUDIO SYSTEM CONTROLLER
- Remove CAR COMMUNICATION COMPUTER
- If necessary, remove ONBOARD MONITOR
- Remove RIGHT GLOVEBOX WITH HOUSING
- Remove SPEAKER
- If necessary, remove SOLAR SENSOR
Unfasten screws (1 and 3).
Pull back instrument panel trim (2) in direction of arrow.
Disconnect available plug connections and remove instrument panel trim (2).
Installation:
Make sure guides (2) on instrument panel trim (1) are correctly seated in respective mountings.
Make sure seals are correctly seated on air ducts.