LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2648 (Steering And Wheel Alignment - Repair - E90) >> 3231 steering column >> 3231090 Removing and installing/replacing steering column

3231090 Removing and installing/replacing steering column

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Cars produced up to 12/2004 have a steering column with a 3-pin plug connection for electric steering column locking. Cars produced after this date have a 4-pin plug connection. Spare parts are offered for both variants.

Necessary preliminary tasks 

Installation: 

Press sleeve into bulkhead and check installation position, correct if necessary.

Release clamping screw (1) on steering column (2).

Installation: 

Tightening torque 32 31 1AZ .

Clean thread to remove all remnants of screw securing adhesive.

Replace clamping screw.

Clamping screw must rest in groove of steering column.

No kinking permitted!

Fig 1: Identifying Clamping Screw On Steering Column
G06175822Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 32 31 2AZ .

Secure steering column against falling out.

Unfasten screws (2).

Tightening torque 32 31 2AZ .

Remove steering column towards rear.

Installation: 

Prior to installing, slide sleeve onto steering column.

Fig 2: Identifying Steering Column Screws
G04726385Courtesy of BMW OF NORTH AMERICA, INC.

Replacement 

After installation